Hitachi U-5100 Instruction Manual page 141

Photometry
ID
10 WL1 （ 260.0nm）
START:Continue; Select function.: ＿
□ Meas. □
1
Fig. 3-47
Table 3-34 Guidance after Sample Measurement
Setting Item
[1] Meas. You can make setting related to measurement.
"New Meas.", "Continue" and "Remeasure" are
selectable.
[1] New Meas. : Selected when newly measuring
[2] Continue
[3] Remeasure : Selected when remeasuring a
3 - 77
ABS
0.423
WL2 （ 280.0nm） 0.268
ABS DIFF= 0.155
ABS Ratio= 1.582
Save □ Print
2 3
Example of Display after Sample
Measurement
(number of samples: 10)
Description
samples with the same calibration
curve.
: Allows you to start measurement
from the number following the
previously measured sample.
When this function is selected, the
guidance given below appears.
Enter the number of samples to be
measured and press the [ENTER]
key.
Input value. ： ＿
No.of Sample [1-140]
Display with 10 samples measured
measured sample. When this
function is selected, the guidance
given below appears. Select a
sample to be remeasured with the
[▲] or [▼] key, set the sample to
cell 1 and press the [START] key to
carry out remeasurement.
To execute auto zero, press the
[AUTOZERO] key.
3.2.3
CELL A