Kinematic Measuring; Stop And Go Measuring - Javad Maxor Operator's Manual

S E T U P A N D M E A S U R I N G
3
Measuring with the Maxor
5. Set up each antenna and receiver as described in "Maxor Receiver
6. Begin your measuring.

Kinematic Measuring

You can use the kinematic measuring method in two ways:

Stop and Go Measuring

3-10 Maxor Operator's Manual
• Static mode – enable (disable for Rover receivers)
Figure 3-7. Advanced->Loop Management
Setup" on page 3-2.
• Stop and go measuring
• Kinematic continuous (trajectory) measuring
The stationary receiver (Base station) is set up at a known point such as
a measuring monument. The receiver continually tracks the satellites
and logs the raw data into its memory. The rover receiver is set up at an
unknown point and collects data in static mode for 2 to 10 minutes.
1. Using PCView, configure and set up the Base as described in
"Static Measuring" on page 3-7.
www.javad.com