Bluetooth Module Firmware; Get Device Type - Javad Maxor Operator's Manual

O P E R A T I O N
4
Loading New Firmware
Notice: If you selected an incorrect RAM file, an error message
displays at the bottom of the dialog box. Reselect the
correct file.
11. Click File->Exit.
12. Clear the receiver's NVRAM (see"Clearing the NVRAM" on

Bluetooth Module Firmware

Bluetooth module firmware is released as a compressed file that you
download and decompress. This file contains the following two files:
Notice: You must load both files when loading new firmware.
These files must come from the same firmware package.
1. In FLoader, click the Device tab and set the Device Type as "Receiver".
2. Click the Program tab and set the Capture Method to "Soft Break
4-26 Maxor Operator's Manual
page 4-17) and update the almanac ("Collecting Almanacs" on
page 2-44) after loading new firmware.
• btloader.ldr – the Bluetooth module RAM file
• btmain.ldp – the Bluetooth module Flash file
Then click Get from Device for device information (Figure 4-19).
Figure 4-19. Get Device Type
Capture" (recommended) (Figure 4-20 on page 4-27).
www.javad.com