Configuring A Base Station's; Jns 2W Uhf 410-470 Radio Transceiver - Javad Maxor Operator's Manual

Configuring a Base Station's JNS 2W UHF 410-470 radio
transceiver
www.javad.com
1. Navigate to the location of the Modem-JNS program and double-
click the Setup.exe icon.
2. Keep the default installation location or select a new location. Click
Finish.
3. Click OK to complete the installation.
For Maxor, the integrated JNS 2W UHF 410-470 radio transceiver
provides TX/RX UHF communications between a Base Station and
Rover. To configure the UHF radio modems, have the following ready:
• Computer running Windows® 98 or newer
• Modem-JNS version 1.7 or newer
• Serial cable (or Bluetooth® wireless technology capabilities)
1. Connect the computer and receiver using an RS232 cable or
Bluetooth® wireless technology.
2. Turn on the receiver.
3. Open Modem-JNS and select the COM port the receiver is
connected to.
4. Click Connect.
There are two scenarios for configuring the radio-modem:
• with a dedicated channel
• with the Free Channel Scan (FCS) mode
C O N F I G U R A T I O N
Radio Configuration
Maxor Operator's Manual 2-27