Loading New Firmware; Receiver And Power Board Firmware - Javad Maxor Operator's Manual

Loading New Firmware

Base and Rover receivers must be loaded with the same firmware version. Use
the latest firmware version, available for download from the JNS website, to
ensure your receiver has the most recent updates.
The Maxor uses FLoader, a Windows®-based utility, to load firmware onto the
receiver and power boards. You can download FLoader to your computer from
the JNS website (http://www.javad.com). For more information, refer to the
FLoader User's Manual, also available on the JNS website.
1.
2.
3.
4.
5.
See the following sections to load the appropriate firmware.

Receiver and Power Board Firmware

www.javad.com
Download and install FLoader, if applicable.
Download the new firmware package to your computer.
Physically connect your receiver and computer using the RS232 cable.
Activate FLoader (Figure 4-14).
On the Connection tab, select the COM port on your computer that connects
with your receiver and select its speed (usually 115200).
Receiver and power board firmware is released as a compressed file that
you download and decompress. This file contains the following three files:
• ramimage.ldr – the Receiver board RAM file
• main.ldp – the Receiver board Flash file
Figure 4-14. Floader Main Screen
O P E R A T I O N

Loading New Firmware

Maxor Operator's Manual 4-23