Maintenance And Component Replacement; What To Do After Scrapping - INVT Goodrive20-UL VFD Series Operation Manual

Goodrive20-UL Series VFD

1.3.3 Maintenance and component replacement

 Only qualified electricians are allowed to perform the maintenance,
 Disconnect all power supplies to the VFD before the terminal wiring. Wait
 Take measures to avoid screws, cables and other conductive matters to
Note:
 Please select proper torque to tighten screws.
 Keep the VFD, parts and components away from combustible materials during
maintenance and component replacement.
 Do not carry out any isolation and pressure test on the VFD and do not measure the control
circuit of the VFD by megameter.

1.3.4 What to do after scrapping

 There are heavy metals in the VFD. Deal with it as industrial effluent.
 When the life cycle ends, the product should enter the recycling system.
Dispose of it separately at an appropriate collection point instead of
placing it in the normal waste stream.
inspection, and components replacement of the VFD.
for at least the time designated on the VFD after disconnection.
fall into the VFD during maintenance and component replacement.
-4-
Safety precautions