INVT Goodrive20-UL VFD Series Operation Manual page 59

Goodrive20-UL Series VFD
Function
Name
code
Polarity
selection
P05.10
of the input
terminals
Switch
P05.11
filter time
Virtual
P05.12 terminals
setting
Terminals
control
P05.13
running
mode
Description
The function code is used to set the polarity of
the input terminals.
Set the bit to 0, the input terminal is anode.
Set the bit to 1, the input terminal is cathode.
BIT8 BIT7
HDI S8
BIT3 BIT2
S4 S3
Setting range: 0x000–0x1FF
Set the sample filter time of S1–S4 and HDI
terminals. If the interference is strong, increase
the parameter to avoid wrong operation.
0.000–1.000s
0x000–0x1FF (0: Disabled, 1:Enabled )
BIT0: S1 virtual terminal
BIT1: S2 virtual terminal
BIT2: S3 virtual terminal
BIT3: S4 virtual terminal
BIT4: S5 virtual terminal
BIT5: S6 virtual terminal
BIT6: S7 virtual terminal
BIT7: S8 virtual terminal
BIT8: HDI virtual terminal
Note: After a virtual terminal is enabled, the
state of the terminal can be changed only in
communication mode.
address is 0x200A.
Set the operation mode of the terminals control
0: 2-wire control 1, comply the enable with the
direction. This mode is
determines the rotation direction by the defined
FWD and REV terminals command.
FWD
K1
REV
K2
COM
BIT6 BIT5
S7 S6
BIT1 BIT0
S2 S1
The communication
widely used. It
Running
FWD REV
command
OFF OFF Stopping
Forward
ON OFF
running
Reverse
OFF ON
running
ON ON Hold on
-54-
Function parameters
Default
BIT4
0x000
S5
0.010s
0x000
0
Modify
○
○
◎
◎