Table of Contents
Advertisement
Chapter 8: Installing the Switch in the RKMT-SL01 Sliding Rack
Installing the Inner Rails on the Switch
Front of
Switch
Front of
Switch
154
The sides of the x950 series switches have two sets of bracket screw
holes. The smaller M3 holes are for the standard brackets that come with
the switch and the larger M4 screw holes are for the inner rails of the
RKMT-SL01 sliding rack. The inner rails are attached to the switch with
four M4 screws on each side.
Figure 99 identifies the screw holes on the sides of the x950-28XSQ or
x950-28XTQm switch and inner rails.
Figure 99. Inner Rail Screw Holes for the x950-28XSQ and x950-28XTQm
Figure 100 identifies the screw holes for the x950-52XSQ or
x950-52XTQm switch and inner rails.
Figure 100. Inner Rail Screw Holes for the x950-52XSQ and x950-
Attach the inner rails to the switch using eight M4 screws included with the
sliding rack. Be sure that the UP arrows on the rails are pointing up and
that the extension brackets extend in front of the switch. Refer to Figure
101 on page 155.
Switches
52XTQm Switches
Advertisement
Table of Contents
