Configuring Member Switches - Part Ii - Allied Telesis x330 Series Installation Manual

Step
6 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
7 Type "Y" for yes.
8 Wait one minute for the switch to start the AlliedWare Plus software.
9 Check the ID LED on the front panel. Do one of the following:
- If the ID LED is displaying the switch's new ID number, go to "Configuring Member
Switches - Part II," next.
- If the ID LED is displaying the wrong number, repeat this procedure.
Configuring
Member Switches
- Part II
Step
1 Start a new local management session on the member switch. Refer to "Starting a
Local Management Session" on page 102.
2 Enter the ENABLE and CONFIGURE TERMINAL commands to move to the Global
Configuration mode.
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
Steps 3 and 4 remove the SFP+ S1 and S2 ports from the stack trunk on the member switch.
Table 14. Configuring Member Switches - Part I (Continued)
Description and Command
Part II has these steps:
Remove SFP+ S1 and S2 ports as the stack trunk.

Designate the Multi-Gigabit copper ports as the stack trunk.

Reboot the switch.

Perform the procedure in Table 15.
Table 15. Configuring Member Switches - Part II
Description and Command
x330 Series Installation Guide for Virtual Chassis Stacking
133