Configuring Member Switches - Part Ii - Allied Telesis AlliedWare Plus Installation Manual

Step
5 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
6 Type "Y" for yes.
7 Wait one minute for the switch to start the AlliedWare Plus software.
8 Check the ID LED on the front panel. Do one of the following:
- If the ID LED is displaying the switch's new ID number, go to "Configuring Member
Switches - Part II," next.
- If the ID LED is displaying the wrong number, repeat this procedure.
Configuring
Member Switches
- Part II
Step
1 Start a new local management session on the member switch. Refer to "Starting a
Local Management Session" on page 142.
2 Enter the ENABLE and CONFIGURE TERMINAL commands to move to the Global
Configuration mode.
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
Table 24. Configuring Member Switches - Part I (Continued)
Description and Command
Part II has these actions:
Designate the trunk type to be Gigabit front panel ports with the

STACK ENABLE FRONT-PANEL-PORTS command in the Global
Configuration mode.
Designate the Gigabit ports of the trunk with the STACKPORT

command in the port interface modes.
Reboot the switch.

Perform the procedure in Table 25.
Table 25. Configuring Member Switches - Part II
Description and Command
x930 Series Installation Guide for Virtual Chassis Stacking
179