Table of Contents
Advertisement
Verifying the
Master Switch
Step
1
Start a new local management session on the master switch.
2
Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
3
Enter the SHOW STACK command and check the display for the following:
- The table should have two switch entries, with the IDs 1 and 2.
- Switch ID 1 is the master switch.
- The master switch should have the priority 1. If it does not, repeat "Configuring the
Master Switch" on page 130. Be sure to perform the STACK PRIORITY command
and to save your changes with the WRITE command.
- Switch ID 2, with its empty fields, is for the provisioned member switch. If the table
does not include this switch, repeat "Configuring the Master Switch" on page 130.
Be sure to perform the SWITCH PROVISION command and to save your changes
with the WRITE command.
- The Operational Status should be Standalone Unit, indicating that stacking is
enabled and that the unit is operating as a stack of one switch. If the status is
Stacking Hardware Disabled, the stacking feature is disabled. Repeat "Configuring
the Master Switch" on page 130. Be sure to perform the STACK ENABLE command
and to save your changes with the WRITE command.
awplus# show stack
Virtual Chassis Stacking summary information
ID Pending ID
1
-
2
-
Operational Status
Stack MAC address
Perform the steps in Table 17 on page 133 to confirm the configuration of
the master switch.
Table 17. Verifying the Master Switch
Description and Command
MAC address
e01a.ba56.c208
-
AT-x950-28XSQ Switch and VCStack Installation Guide
Priority
Status
1
Ready
-
-
Standalone unit
0000.ab56.d4a8 (Virtual MAC)
Role
Active Master
Provisioned
133
Advertisement
Table of Contents
