Verifying The Master Switch; Table 8: Verifying The Master Switch - Allied Telesis XS900MX Series Installation Manual

Table 7. Configuring the Master Switch - Part II (Continued)
Step
10 Restart the switch with the REBOOT command.
awplus# reboot
reboot system? (y/n):
awplus#
11 Type "Y" for yes.
12 Wait two minutes for the switch to initialize the management software.
13 Go to "Verifying the Master Switch" on page 115.
Verifying the
Master Switch
Step
1 Start a new local management session on the master switch. Refer to "Starting a
Local Management Session" on page 86.
2 Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
Description and Command
Perform the steps in Table 8 to confirm the configuration of the master
switch.
Table 8. Verifying the Master Switch
Description and Command
XS900MX Series Installation Guide for VCStack
115