Table of Contents
Advertisement
Fuel Dispensers TATSUNO EUROPE ‐ Installation and User Manual , revision 10, January 2022
3.3. DISPENSER LOCATION
3.3.1. IN GENERAL
The manufacturer recommends placing dispensers on safety islands of fuel stations in such a way that the
direction of arrival of the vehicles to the dispenser corresponds to the orientation of the arrow, see Figure 1.
The same figure shows the numbering of the dispenser products.
The space for dispenser installation must be structurally secured so that the possibility of dispenser damage by
an incoming car and following medium leakage into atmosphere is avoided as best as possible. Therefore, it is
suggested to:
Secure the access to the refilling position in straight direction
Install the dispenser onto an elevated refuge with the following parameters
‐ refuge elevation above the surrounding road at least 150 mm
‐ refuge width at least 1,500 mm / refuge length at least 4,000 mm
In case of dispenser installation directly onto the surface without a refuge it is necessary to secure the
dispenser against collision with a vehicle by using a tube guard with the following parameters:
‐ guard width at least 1,500 mm (refuge width) / length 2,000 mm
‐ height of the upper edge of the tube above the road at least 450 mm
Example of the dispenser location at the fuel station – see Figure 68.
If there is any fixed obstacle (column, wall, etc.) nearby the dispenser, the minimum separation distance of the
dispenser from such obstacles must be observed due to safe operation and maintenance – see Figure 67.
Picture 66 – Lifting the dispenser from the wooden transport pallet
(Position 6 ‐ Transport holes for carrying fork 100 mm x 40 mm)
91
Advertisement
Table of Contents
