Daily Totalizers Reset (P15); Error Message Codes History (P20); Error Message Code Statistics Of Filling Point (P21, P22, P23, P24) - tatsuno OCEAN TOWER Series Installation And User Manual

4.1.18. DAILY TOTALIZERS RESET (P15)
The parameter is used to reset all daily totalizers of dispensing hoses. After setting the
parameter value to <1> and confirming (<E> + <1> + <E>), all totalizers that are part of
parameters P01 and P02 will be reset to 0. The message "done" appears and the parameter
value goes to 0.
Parameter Meaning
P15=0 Idle status
P15=1 Daily totalizers P01 and P02 reset to 0
4.1.19. ERROR MESSAGE CODES HISTORY (P20)
The function is used to display the history of the last 100 error message codes that have occurred and displayed
on the dispenser. The table of error messages codes is given in chapter 6.2.1. After switching to parameter P20,
the display shows the code of the last error message and the designation for the filling point where the error
occurred A, B, C or D (e.g., E41‐01 pulse generator connection error at input PUL1 for filling point A). After
pressing the <E> key, the date and time of the fault will be displayed. After pressing the <+> key, the code of the
penultimate error message code, etc. appears on the display.
Parameter Meaning
(P)20‐00 code of the last error
(P)20‐01 code of the penultimate error
... ...
(P)20‐98 99th error code in the sequence
(P)20‐99 100th error code in the sequence
NOTE
If two identical error message code occur in a row, then only the last one is displayed.
4.1.20. ERROR MESSAGE CODE STATISTICS OF FILLING POINT (P21, P22, P23, P24)
The parameter is used to display the cumulative numbers of individual error messages for a given filling point.
The first line of the display shows the error message code and the second line the frequency of the error. After
switching to parameter P21 (error message code statistics for filling point A), the display shows the fault
frequency for error message code E0. After pressing the <+> key, the frequency of the error message code E1...
etc... appears on the display. The table of error message codes is given in chapter 6.2.1.
Parameter Meaning
P21 Error message code statistics of filling point A
P22 Error message code statistics of filling point B
P23 Error message code statistics of filling point C
P24 Error message code statistics of filling point D
NOTE
A filling point (dispensing site, dispensing point) is defined as a place where one independent fuel
dispensing (one pumping) can be performed. By default, a double‐sided dispenser has two filling points ‐ A and B
(see Figure 79), a single‐sided dispenser has one filling point ‐ A. However, there are variants of dispensers,
especially combined dispensers, where two simultaneous pumping can be performed on one side of the dispenser
diesel + AdBlue). The double‐sided dispenser then has four filling points A, B, C and D (see Figure 80) and the single‐
sided dispenser has two filling points A and B. Each filling point must have one main display and can serve one to
five dispensing hoses.
TATSUNO EUROPE a.s., www.tatsuno‐europe.com
Factory setting
ENT
A
E41‐01
ENT
20‐00
Err 0
0
P21
120
M0
0
230821
094706
20‐00
Err 1
35
P21
0
P15