Table of Contents
Advertisement
Fuel Dispensers TATSUNO EUROPE ‐ Installation and User Manual , revision 10, January 2022
Parameters of electric motors
Table 15 shows the basic parameters of two basic types of electric motors used in TATSUNO EUROPE
dispensers.
NOTICE
When the electric motor is connected, check the correct direction of rotation! The correct direction of
rotation is indicated by the arrow marked on the pump pulley, see Figure 75.
3.5.2. POWER SUPPLY OF ELECTRONIC COUNTER, SWITCHING ELEMENTS AND HEATING
Counter and switching circuits are supplied via a 3‐wire power cable H05VV5‐F 3x1,5 (see Table 16), or if
the dispenser is equipped with heating (e.g., AdBlue® dispensers) via a 5-wire power cable H05VV5F 5x1.5
(Table 17). The power cable is always brought from the main switchboard in the booth to the first
hydraulic module of the dispenser into the distribution power supply box. From the distribution box, the
Table 15 – Parameters of electric motors
Pump electric motor
V80 TL 4P (RAEL)
asynchronous motor
230/400V; 50Hz
current 2.2 A
power supply 0.75 kW
1410 rpm
Ia/In = 4.4
IP 55
T3
cos φ = 0.8
Ex II 2G Ex db IIB T3 Gb
EPT 16 ATEX 2476X
Figure 75 – Check of the pump motor direction of rotation (arrow)
Vacuum pump electric motor
J2071B2H2305FZ
asynchronous motor
230/400V; 50Hz
current 1.45 A
power supply 0.55 kW
2840 rpm
Ia/In = 4.9
IP 54
T3 (t
= 10 sec)
E
cos φ = 0.78
Ex II 2G Ex e IIC T3 Gb
EUM1 12 ATEX 0744
103
Advertisement
Table of Contents
