Fuel Dispensers TATSUNO EUROPE ‐ Installation and User Manual , revision 10, January 2022
4.4. TBELTX COUNTER
The TBELTx electronic counter is set using the 4‐button keyboard or the preset keyboard if installed on
the dispenser. Using the keyboard, you can:
set unit prices of fuel products (in manual operation)
read non‐resettable electronic litre totalizers of all delivery hoses
change the dispenser working mode
4.4.1. SETTING THE FUEL UNIT PRICE
If the dispenser operates in the manual mode, then the product unit prices saved in the calculator memory
where a single fuel unit price is assigned to each pump are used for calculation of the sum for dispensed fuel.
Changes of the fuel price on the display will take effect after the next time the nozzle is taken out. A zero price
value for all fuel products is set at the factory. It is necessary to set a non‐zero price, or dispensing will not
commence and the error message E30 – "zero price" will appear.
the fuel unit prices sent from the control computer at each dispensing authorization is used to calculate the total
dispensed sum. Prices saved in the parameter P03 are non‐functional.
How to set the fuel price in a manual mode
The price change can only be made between powering on the counter and the first delivery on the dispenser.
Turn the counter power supply off
and on.
Press and hold the button 2
simultaneously with button 4 for at
least 3 seconds.
The middle line shows the number of
the set nozzle (product), the unit price
is shown on the lower line. The price
is set by individual locations. The set
digit flashes.
Use the button 1 to change the value
of the flashing location.
By button 2 you can move between different orders.
Use the button 3 to change the number of the nozzle for which the price is being set.
To quit the price setting, press the button 4.
4.4.2. READING ELECTRONIC TOTALIZERS
The TBELTx counter is equipped with electronic volume totalizers for each delivery hose / nozzle. The
value of these totalizers can be determined using the preset keyboard or by the command on the
communication line. Totalizer reset can be done using the P18 configuration parameter. Totalizer reset
can only be done if the SW1‐1 switch is set to OFF.
If the dispenser works in the automatic mode,
Nozzle number
1
2
3
4
129
P r i c E
1
1 1 4 0
The set digit flashes
€
L
€/L