Dispenser Handling - tatsuno OCEAN TOWER Series Installation And User Manual

3.2.1. DISPENSER HANDLING
The following rules must be observed when loading, unloading and setting up the dispenser.

Use a forklift to handle the fuel dispenser firmly attached to the wooden pallet. Follow the safety rules
described by the forklift manufacturer.

When unloading and loading the fuel dispenser from or into the transport vehicle, use the direction
from the side of the vehicle. Loading from the rear of the vehicle is dangerous and can damage the
vehicle, the stand and injure people (see figure below).
Picture 65 – Permitted and forbidden direction of loading and unloading of the dispenser
(1‐transport vehicle, 2‐dispenser on a pallet, 3‐forklift, 4‐wooden pallet, 5‐permitted direction of loading and unloading)

When installing the dispenser on the site, first remove the dispenser covers (doors) and loosen the
anchor bolts between the wooden pallet and the dispenser. Then pick up the dispenser from a wooden
pallet and place it on the prepared base frame on the site. Use the holes in the dispenser for the 100 x
40 mm load forks to lift – see Picture 66, position 6).
Picture 64 – Using of a forklift during loading and unloading
90
TATSUNO EUROPE a.s., www.tatsuno‐europe.com