Setting The Time & Time Format - Visonic rMaster-360 User Manual

1 For detailed instructions on how to select User Settings – refer to sections A.1 and A.2.
2
The LED will extinguish after several seconds. In case of difficulties in communication with the control
panel, the LED may blink for several seconds more while trying to establish communication. During this
period of time the keyfob keys are disabled.
3 The display shows the first enrolled Keyfob (Keyfob No.1) of the 32 keyfobs .
4
To cancel enrollment press the
5
If partition is enabled, continue to step 6.
6 You can now enroll another keyfob. You can also select another option in the User Settings menu (see
section A.1), or quit programming (see section A.2).
7
If the keyfob was previously enrolled in the system, the Virtual Keypad display reads "
" and then switches to the name of the keyfob alternating with its ID number.
ENROLLED
8
Before you delete a keyfob, identify the keyfob either by the keyfob No., for example, F06, or by the ID
number of the keyfob that appears on the display, and then make sure that it is the keyfob you wish to delete.
9 Enrollment by Device ID:
Step 4b enables you to register the device ID and to complete the programming process without being in
possession of the device itself (can also be performed off-site by the installer). Enrollment can then be
completed at a later stage by following the same enrollment procedure described in Step 3 without
entering the User Settings menu.
10
This setting can be performed only after completing steps 1 - 5 of section B.7A.
11 
The symbol now appears next to the newly selected Partitions.
12
You can now repeat steps 2 - 7 to program or edit another keyfob.
13
To cancel the procedure, press the
14
You can now add or delete another keyfob, select another option in the User Settings menu or quit
programming (see sections A.1 A.2).
B.8 Setting the time and format
 Here you can program or adjust the built-in-clock to show the correct time in the required time format.
 You can select between a 24 hour and a 12 hour (AM/PM) time format.
Carefully read the section titled "Additional Information" according to the indicated references

table at end of this section.
A. To set the time format
1.
TIME & FORMAT
2.
EU FORMAT-24H 
or
US FORMAT-12H
3.
D-307082 PowerMaster 360 User's Guide
Additional Information (section B.7)
button.
button.
Enter the [USER SETTINGS] menu and select the [TIME & FORMAT] option
and press .
1
The display shows the currently selected time format.
Click the or
format, for example, "US FORMAT-12H" and press
MENUS AND FUNCTIONS
button until the display shows the desired time
ALREADY
1 etc. – see
2
to confirm .
27