RAPID CONFIGURATION
STEP 7 - TEST MODE
Use a code suitable to your application to test the reading performance of the system.
1. Enter the Test function by pressing and holding the X-PRESS push button until the
2. Release the button to enter the Test function.
3. To exit the Test, press the X-PRESS push button once.
NOTE
The Bar Graph has the following meaning:
In case of No Read condition, only the STATUS LED is on and blinks.
34
MATRIX 300N
Test LED is on.
Once entered, the Bar Graph on the five LEDs is activated and if the reader starts
reading codes, the Bar-Graph shows the Good Read Rate.
Figure 13 - X-PRESS Interface: Test Function
By default, the Test exits automatically after three minutes.
Figure 14 - Test Function Bar Graph