Fieldbus Connection - Datalogic Matrix 300N Series Product Reference Manual

TYPICAL LAYOUTS

FIELDBUS CONNECTION

In this layout a single reader functions as a Slave node on a Fieldbus network. The data
is transmitted to the Host through an accessory Fieldbus interface board installed inside
the CBX500 connection box.
Reader configuration can be accomplished through the Ethernet interface using the
DL.CODE configuration program.
Data can be transmitted on the RS232 auxiliary interface irrespective of the Fieldbus
interface selection to monitor data.
When One Shot or Phase Mode operating mode is used, the reader can be activated by
an External Trigger (photoelectric sensor) when the object enters its reading zone.
Power
Matrix 300N
Alone
All devices always support multiple output channels (i.e. for data monitoring).
88
MATRIX 300N
CAB-DSxx-S

Host
Figure 68 - Fieldbus Interface Point-to-Point Layout
CBX500


Fieldbus Interface (Profibus, DeviceNet, etc.)

 Auxiliary Serial Interface (RS232 - Data Monitor)
 External Trigger (for One Shot or Phase Mode)