Internal Network Configurations - Datalogic Matrix 300N Series Product Reference Manual

SOFTWARE CONFIGURATION
Reader #3

INTERNAL NETWORK CONFIGURATIONS

Internal Network configurations (also called Master/Slave configurations), are designed
to collect data from several devices
send data output to the Host system.
DL.CODE has a Net Autoset feature for the Internal ID-NET Network which automatically
recognizes and assigns addresses to all connected Slave readers.
In order to automatically recognize the ID-NET Slaves, all devices must be physically
installed and electrically connected (including ID-NET network wiring).
The general procedure (also detailed in the following paragraphs) is to:
1. Mount all the readers mechanically (refer to "
2. Connect to the designated Master device in DL.CODE and open the Setup Internal
3. Depending on the application, select Multidata, Synchronized Phase Mode or Syn-
4. Connect to each Slave reader via Ethernet and set the Slave specific parameters
5. For Synchronized networks Verify/Test network performance. See "
6. Perform the Backup current Internal Network configurations procedure. See
156
MATRIX 300N
and "
Mounting And Positioning Matrix 300N" on page 57
"
ID-NET Interface" on page 67
Internal Network Role = Slave).
In order to automatically recognize the ID-NET Slaves, all devices must be physi-
cally installed and electrically connected (including ID-NET network wiring). Run
DL.CODE and verify that all the devices are discovered and shown in the device list
area.
Network Configuration. You will be prompted to change the device to Master.
Click OK. The Slave units will automatically be recognized. See "
.
tion" on page 157
chronized PackTrack Configuration.
depending on the application type. Save each Slave specific configuration. See
"
Multidata ID-NET Network Configurations" on page 159
Network Configurations" on page 163
Slave Synchronized Configuration" on page 167
" .
Backup" on page 171
connected
together in an ID-NET™ network and
Mechanical Dimensions" on page 54
) with factory default settings (Layout Type = Alone,
.
.
) and electrically (refer to
Master Configura-
or "
Synchronized ID-NET
Verify Master/