Learn - Datalogic Matrix 300N Series Product Reference Manual

Learn

4. Enter the Learn function by pressing and
5. Release the button to enter the Learn func-
If the autolearning cannot be reached after a time-
out of about 3 (three) minutes, Matrix 300N will
exit without saving the parameters to memory, the
Learn LED will stop blinking and in this case Matrix
300N emits a long low pitched beep.
1. The Code Autolearn procedure will not recognize
NOTE
NOTE
NOTE
NOTE
holding the X-PRESS push button until the
Learn LED is on.
tion. The Learn LED will blink until the proce-
dure is completed.
The Learn procedure ends when the Image
Processing and Decoding parameters for a sin-
gle code are successfully saved in the reader
memory, the Green Spot is activated, the
Learn LED will stop blinking and Matrix 300N
emits 3 high pitched beeps
the following symbologies: Postal Codes, Phar-
macode, MSI, Standard 2 of 5, Matrix 2 of 5.
The Grade A Barcode Test Chart cannot be used to set the Code 128 sym-
bology (even though the reader successfully reads the code). Use the
application specific code if you need to set this symbology.
When using X-PRESS or the BM150 menu to perform Auto-Learn, only a
single code can be configured (successive Learns will substitute the cur-
rent code). To configure multiple codes, use the DL.CODE Auto-Learn pro-
cedure.
You can always exit from any X-PRESS function at any time by pressing
the X-PRESS push button once. After a short delay the procedure is can-
celed.
If you have used this procedure to configure Matrix 300N, go to step 7.
1
.
STEP 4 - X-PRESS CONFIGURATION
Figure 9 - X-PRESS Interface:
Learn Function
PRODUCT REFERENCE GUIDE
7