Bm150 Display Module Configuration And Messages; Configuration Through Dl.code; Accessing The Hmi Interface Through Keypad And Display Menu - Datalogic Matrix 300N Series Product Reference Manual

SOFTWARE CONFIGURATION

BM150 DISPLAY MODULE CONFIGURATION AND MESSAGES

The BM150 display module is an optional accessory for the CBX500 connection box.
Although independent, it is an extension of the reader's HMI Interface, so through its
keypad it provides execution of HMI features such as Test, Focus/Locate, Calibration and
Code Setting. It also displays device status information, reading results, diagnostic and
network messages. Since it connects through the BM100 backup memory module, it
provides access to Backup and Restore features through its Extended menu.

Configuration Through DL.CODE

BM150 must be detected through the BM100 backup memory module at power-up/
reset and this is done through a command setting in DL.CODE. By connecting the reader
to DL.CODE the following parameters can be managed.
In the Device>Settings>Settings>Maintenance window:
•
Checked (Enabled): the BM100 backup memory module will be detected on power-up/
reset; therefore the BM150 display module (if present), will also be enabled.
Unchecked (Disabled): the BM100 backup memory module will not be detected on
power-up/reset; therefore the BM150 display module (if present), will also not be
enabled.
•
Reading Mask Only: the Reading Mask screen is sent to the BM150 display.
Reading Mask/Device State: the Reading Mask/Device State screen is sent to the BM150
display.

Accessing the HMI Interface Through Keypad and Display Menu

Through its keypad and display, the BM150 provides a remote extension of the reader's
HMI Interface. The HMI default menu items can be accessed as well as the View menu
for Master devices and the Extended menu for Backup and Restore functions.
178
MATRIX 300N
Enable BM100 Detection
BM150 Display Layout (Master Only)
Up Enter Down
Figure 100BM150 Keypad