Step 5 - Test Mode - Datalogic DS2100N Quick Reference Manual

STEP 5 – TEST MODE
Use a code suitable to your application to test the system. Alternatively, you can use the Datalogic Test Chart
(Interleaved 2/5 or Code 39).
1. Enter the Test mode function by holding the X-PRESS™ push button pressed until the TEST LED is on.
2. Release the button to enter the Test mode function.
Once entered, the Bar-Graph on the five LEDs is activated and if the scanner starts reading barcodes the
Bar-Graph shows the Good Read Rate. In case of no read condition, only the STATUS LED is on and blinks.
3. To exit the Test Mode, press the X-PRESS™ push button once.
By default, the Test Mode exits automatically after two minutes.
NOTE
READY
GOOD
SETUP
TRIGGER
LEARN
COM
TEST
STATUS
Figure 8 – X-PRESS™ Interface: Test Mode Function
DS2100N QUICK GUIDE
green
green
yellow
yellow
red
11