Software Configuration; Dl.code System Requirements - Datalogic Matrix 300N Series Product Reference Manual

CHAPTER 7

SOFTWARE CONFIGURATION

Software configuration of your Matrix 300N for static reading or simple code reading
applications can be accomplished by the Rapid Configuration procedure using the
X-PRESS HMI (which requires no external configuration program). This procedure is
described in
For the majority of applications however you will use DL.CODE, connecting to the
reader through the on-board Ethernet interface. See

DL.CODE SYSTEM REQUIREMENTS

CAUTION
To install and run DL.CODE you should have a Laptop or PC that meets or exceeds the
following:
•
•
•
•
•
•
CAUTION
134
MATRIX 300N
, Steps 3-4.
Chapter 1
DL.CODE does not currently support Windows Embedded (often used in
industrial PCs and/or PLCs).
2.00 GHz or faster microprocessor
Windows: 7, 8, or 10
1 GB RAM
2 GB hard disk for 64-bit machines; 1 GB hard disk for 32-bit machines
100 Base-T Ethernet
One 19" or larger monitor (optimized for 1280x1024 resolution)
The Windows XP operating system is no longer supported by DL.CODE.
, Steps 5-6.
Chapter 1