Conduct Relative Value Measurement - Owon FDS Series User Manual

window. Click Hold key below and H is displayed at the multimeter display
window, and the current reading keeps on the screen.
(2) Click Hold again to exit this mode.

Conduct Relative Value Measurement

For relative measurement, the reading is the difference between the stored
reference value and the input signal.
(1) Click the Multimeter display window on the screen or press Setting key at
the multimeter area of the front panel to display the multimeter setting
window. Click Relative Value key below and △ is displayed at the
multimeter display window, then enter the relative value measurement
mode; the measured value at this point is considered as a reference value
and displayed below the current reading.
In this mode, Current Reading = Input Value – Reference Value.
(2) Click Relative Value again to exit this mode.
Note: This function is not available for measuring the resistance and diode and
conducting on-off test.
8.Use the Multimeter
129