To Set Channels; To Set Signals - Owon XDS3204AE Manual

To see the output of the generator, connect the other end of the BNC cable to one of the
input channels on the front of the oscilloscope.

To Set Channels

To Switch Channels in Menu Settings
Push button to switch between CH1 menu, CH2 menu, and Channel Copy menu.
To Turn On/Off Output of Channels
Push or
will be lighted when the corresponding channel is tuned on.

To Set Signals

You can set and output sine, square, ramp, pulse, and arbitrary signals.
(1) Push button to show the bottom menu of generator.
(2) Select the desired waveform in the bottom menu, the corresponding menu is displayed
on the right.
(3) The parameters can be set in the right menu.
Select Frequency in the right menu (if Frequency is not displayed, select Period
E.g.
and push it again to switch to Frequency). Set the parameter in the right menu, see
below.
Three methods to change the chosen parameter:
 Turn the M knob to change the value of cursor position. Press
key to move the cursor.
 Use the soft keyboard: Push the M knob, a soft keyboard will pop up. Turn the M
knob to move between the keys. Push the M knob to input the chosen key.
4.Use the Arbitrary Function Generator (Optional)
Figure 4-1 Generator Output Ports
to turn on/off output of the corresponding channel. The indicator
22
/ direction