Honeywell DCP551 Mark ΙΙ User Manual page 64

Mode event
This event goes on or off depending on controller mode, alarm generation and other
states.
It cannot be combined with the event standby function but with the on delay function. It
does not set event set values (operating points) or hysteresis.
• Basic operations
• Alarm
• ADV
The following types are provided.
RUN + HOLD + END + FAST
HOLD
READY + READY FAST
END
G.SOAK wait
MANUAL
During auto-turning execution
FAST + READY FAST
Console setting operation
RUN
ADV (advance)
Full alarm (logical OR)
PV range alarm
Instrument alarm
PV1 selected
PV2 selected
Battery voltage drop
The event goes on when the specified instrument state is reached and is off at other
times.
Alarms are of two types: PV range alarm group (alarm code number 01 to 04) and
instrument alarm group (alarm code number 91 to 99 and battery voltage drop).
When the event type is all alarm, the event goes on if one alarm occurs.
When the event type is a PV range alarm, the event goes on if one alarm in the PV
range alarm group goes on.
When the event type is an instrument alarm, the event goes on if one alarm in the
instrument alarm group goes on.
When ADV (advance) is executed, the event goes on for 1 second. This function is
valid during on delay.
Chapter 5. FUNCTIONS
5-15