Setting Pattern Link Items - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 8. PROGRAM SETUP

Setting pattern link items

Display
NOTE
8-18
(1) In the set value display state, move to the pattern link item to be set for the segment
on the programming map.
(A pattern link item is a program setting and is the same for each segment.)
(2) Press the ENTER key to make display panel 2 flash (registration of first setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the pattern link
value.
Setting range:0 to 99
0
1 to 99: program number at pattern link destination
(4) Press the ENTER key to stop the flashing on display panel 2.
(Pressing the FUNC and CLR keys causes display panel 2 to return to unset state
0
" "and the flashing stops.)
Set program value
at link destination
P A T T E R N L I N K
• A pattern link item is a program setting and is the same for each segment.
C60
• When setup data
skipped and not displayed.
A pattern link item setting does not use subfunctions.
: no pattern link
PROG
Program
number
PROFILE
Pattern trend
is set to 1, a pattern link item on the programming map is
SEG
Segment
number