Installation; Panel Cutout Dimension - Honeywell DCP551 Mark ΙΙ User Manual

3-2 Installation

This section describes installation procedures.

Panel cutout dimension

HANDLING PRECAUTIONS
Use 2mm thick steel panels in setting up the DCP551.
200 or more
Install the DCP551 in a location where the lower panel is not exposed to temper-
atures that exceed the operating temperature range (0 to 50°C). Make sure that
the temperatures above and below the controller meet specified requirements.
Chapter 3. INSTALLATION AND MOUNTING
Unit : mm
+1
138
0
3-3