Mode; Mode Types - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 5. FUNCTIONS

5-3 Mode

Mode types

Program operation
Constant value control
READY
5-24
Modes are listed below.
Mode Program operation
Constant value
control
The program is run according to SP, time, events and other settings made in program
patterns 1-99.
The control is run according to SP and events made with the constant value control data.
READY indicates that the program is ready to run.
MV becomes fixed and events whose operation depends on values set in the segments
are turned off. Note, however, that DCP551 state dependent events still run.
Program numbers between 1 to 99 and set segment numbers can be selected during pro-
gram operation.
All setup data, some event configuration data and some constant value control data para-
meters can be changed in the READY mode.
Memory cards can also be used in the READY mode.
READY AUTO
MANUAL
READY FAST AUTO
MANUAL
RUN AUTO
MANUAL
HOLD
AUTO
MANUAL
FAST AUTO
MANUAL
END
AUTO
MANUAL
READY AUTO
MANUAL
RUN
AUTO
MANUAL