Modifying Individual Items And Exiting The Setting Mode - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 7. PARAMETER SETUP

Modifying individual items and exiting the setting mode

HANDLING PRECAUTIONS
7-2
Pressing the ENTER key while an individual item is displayed causes the set value to
flash and enables the registration state. At this point, the ↑ ↑ key and ↓ ↓ key allow you to
increase or decrease the values, while the ← ← key and → → key move the digit positions
on the display at which the values flash.
Pressing the ENTER key after the flashing number has been changed to the desired
value stops the flashing, the number reverts to the on state and the new setting is stored
in internal memory.
Modification of settings is terminated by pressing either the PARA key (valid for vari-
able parameters and event configuration data), PID key (valid for PID parameters and
constant value control data), SETUP key (valid for setup data) or DISP key. Pressing
the PARA key, PID key or SETUP key moves the cursor to the next item stops the
flashing and the number reverts to its normal on state.
Pressing the DISP key enables the normal display mode.
Should display panel 2 showcduring display of an individual item or pressing the
ENTER key not enable the registration state, it means that settings cannot be made or
modified for that item.
PA01
• When is set to more than 1 in a variable parameter setting,
items beyond are not displayed.
PA02
when is set to more than 1.
• Event configuration data settings cannot be changed when
value more than 1. Also, when
and some auxiliary settings (output points of code events) cannot be
changed.
• PID parameter settings cannot be changed when
• Setup data settings cannot be changed when
than 1 and cannot be displayed in modes other than the READY mode.
• The constant value control data setting cannot be changed when
to 4 or 5. And, since the FUNC and PID keys are invalid in modes other than
the READY mode, a
PA03
and items beyond cannot be changed
PA02
is set to 0 or 1, the event type setting
ConSt
setting cannot be displayed or changed.
PA03
PA02
is set to a
PA02
is set to 4 or 5.
PA02
is set to a value more
PA02
and
is set