Display Items; Setting Pattern Items - Honeywell DCP551 Mark ΙΙ User Manual

Display items

Display panel no. 2
Message display

Setting pattern items

Items displayed are shown in the figure below.
Basic display contents LED
Display panel no. 1
SP
TM
(1) In the set value display state, move to the segment pattern item to be set on the pro-
gramming map.
(2) Press the ENTER key to make display panel 1 flash (registration of first setting).
(3) Use the ↑, ↓, ←, and → keys to set the first setting (SP).
Setting range: SP limit lower limit to upper limit
(SP limit is set using setup data
(4) Pressing the ENTER key stops display panel 1 from flashing and causes display
panel 2 to start flashing. (This starts start registration of the second setting.) Instead
of pressing the ENTER key, press the FUNC and ENTER keys to switch between
RAMP types (selecting RAMP-X ⇔ RAMP-T, or RAMP-X ⇔ RAMP-E is made
C61
with setup data ).
(5) Use the ↑, ↓, ←, and → keys to make the second setting (time).
Setting range: 0:00 to 500:00, 0.0 to 3000.0
(Time units are selected using setup data
Since a colon ":" cannot be displayed, the decimal point is used instead.)
(6) Press the ENTER key to stop display panel 2 from flashing.
Chapter 8. PROGRAM SETUP
Program/segment number display
Displays numbers of programs
and segments being set.
Lights the decimal point with the program
setting status.
PROG SEG
Program
Segment
number
number
PROFILE
Tendency of
the pattern
C66 C67
and .)
C62
to set Hour/min, Min/sec, 0.1 sec.
Profile display
8-5