Setting Event Items - Honeywell DCP551 Mark ΙΙ User Manual

Setting event items

HANDLING PRECAUTIONS
When the event is a PV event
Display (PV events)
NOTE
Note that when setup data
are skipped and not displayed.
(1) In the set value display state, move to the segement event item to be set on the
programming map.
(2) Press the ENTER key to make display panel 1 flash (registration of first setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the event operating
point.
Setting range : OFF –19999 to +20000 SPU
: OFF 0 to 20000 SPU (for absolute value deviation events)
: OFF –5.0 to +105.0% (for MV events)
(4) Press the ENTER key to stop the flashing on display panel 1. (Pressing the FUNC
and CLR keys causes display panel 1 to return to unset state "-----" and the
flashing stops.)
Set operating point
Event number
Event type
Unset values are indicated as " ----- ".
A PV event setting consists of a setting (including OFF) and a subfunction. A subfunc-
tion cannot be used when a setting has not been made " ----- ".
Chapter 8. PROGRAM SETUP
C57
is set to 1, event items on the programming map
PROG
Program Segment
number
number
PROFILE
Pattern trend
SEG
8-7