Chapter 8. PROGRAM SETUP
Deleting programs
Display
8-20
(1) In the set value display state, move to the start of the segment pattern item to be
deleted on the programming map.
Move to the first segment of the program to delete the entire program.
(2) Press the ENTER key to make display panel 1 flash (registration of first setting).
(This the same as for pattern item settings.)
(3) Press the FUNC and CLR keys and you are prompted to confirm program deletion.
CLEAr
"
" flashes in display panel 1.
(4) Press the ENTER key to delete the program.
(5) The set value display state appears and "-----" is shown in both display panel 1 and 2.
E N T
- - > C L E A R
D I S P - - > Q U I T
• Segments that have not been set and unset values for SP and time are indicated by
"-----".
• A program that is running (in RUN, HOLD, FAST, END or READY FAST mode)
cannot be deleted.
PROG
SEG
Program
Segment
number
number
PROFILE
Pattern trend