Honeywell DCP551 Mark ΙΙ User Manual page 127

No. Item code
Auxiliary output 2 type
48
C 48
49 Auxiliary output lower limit (4mA)
C 49
Auxiliary output upper limit (20mA)
50
C 50
Unused
51
C 51
52 SP output lower limit (4mA)
C 52
SP output upper limit (20mA)
53
C 53
54 Unused
C 54
55 Unused
C 55
56 Unused
C 56
Programming item
57
C 57
event
58 Programming item
C 58
PID group, output limiter group
Programming item
59
C 59
G.SOAK, PV shift, repeat
Programming item
60
C 60
PV start, cycle, pattern link
61 Programming system
C 61
Programming time unit
62
C 62
Time display
63
C 63
(display panel 2)
64 Unused
C 64
65 SP decimal point position
C 65
66 SP limit lower limit
C 66
SP limit upper limit
67
C 67
68 Unused
C 68
Unused
69
C 69
Unused
70
C 70
Factory default
Item
settings
0
0 SPU
10000SPU
----
0 SPU
10000SPU
----
----
----
0
0
0
0
0
0
0
----
1
PV1 range
lower limit
PV1 range
upper limit
----
----
----
Chapter 7. PARAMETER SETUP
User
Settings and descriptions
settings
0: SP
1: PV
2: Deviation (DEV)
3: Manipulated variable (MV)
4: PV1
5: PV2
[Description:]
----- is displayed and setting cannot be performed on
model without auxiliary output or with one auxiliary
output.
Ð19999 to +20000 SPU (
Ð1999.9 to +2000.0% (
[Description:]
----- is displayed and setting cannot be performed on
model without auxiliary output or with one auxiliary
output.
[Description:]
----- is displayed and setting cannot be performed.
Ð19999 to +20000 SPU
[Description:]
----- is displayed and setting cannot be performed when
is not equal to 0.
C21
[Description:]
----- is displayed and setting cannot be performed.
0: Displayed
1: Not displayed
0: Displayed
1: Not displayed
0: Displayed
1: Not displayed
0: Displayed
1: Not displayed
0: RAMP-X and RAMP-T (
1: RAMP-X and RAMP-E (ÆSP) combined
0: hours, min (SPU/hour for RAMP-T)
0: min, sec (SPU/min for RAMP-T)
0: 0.1 sec (SPU/sec for RAMP-T)
0: remaining segment time
1: total operation time (after READY
[Description:]
----- is displayed and setting cannot be performed.
0 to 4
A setting of 0 means no decimal point and a setting between 1
and 4 indicates the number of decimal digits.
[Description:]
This setting is reflected in ÒPVU (SPU)Ó units.
Ð19999 to +20000 SPU
[Description:]
When to are set,
C01 C06
automatically set as the upper limit and lower limit of the
range.
[Description:]
----- is displayed and setting cannot be performed.
not equal to 3)
C48
set to 3)
C48
) combined
q
®
RUN start)
and are
C66 C67
7-25