Chapter 8. Program Setup; Program Setup; Selecting Number Of Program To Operate - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 8. PROGRAM SETUP

8-1 Program Setup

Programming is enabled in the normal display mode. When the DCP551 is not in the normal mode display, press the
DISP key to invoke it. Programming is simpler if you set down the objectives of the program on a program work
sheet before you start programming.
NOTE

Selecting number of program to operate

Selecting program number before programming
HANDLING PRECAUTIONS
Selecting program number during programming
For ease of use, please enlarge the copy of the DCP551/552 Program Work Sheet
located after page 12-18.
Numbers can be selected in one of two ways.
• before programming
• during programming
Press the PROG key in the normal display mode in the READY mode. When the pro-
gram number starts flashing, use the PROG key or the ↑, ↓, ←, or → key to select a
number.
Program numbers cannot be selected during external switch input.
See "Section 6-3 Selecting Programs" (page 6-7) for details.
Press the FUNC and PROG keys in program setting state so that the program number
starts to flash. Use the ↑, ↓, ←, or → key to make the desired changes and press the
ENTER key to enter them. Note, however, that you must after exiting the registration
state (when set values flash) with the ENTER key, press the FUNC and PROG keys.
When programs are selected in this way, the pattern items are displayed on the program-
ming map.
This allows you to select a program number of a program other than the one processed
in the RUN mode. It also allows you to select the number of another program using the
external switches.
8-1