Starting Programming; State Transition - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 8. PROGRAM SETUP

Starting programming

Key operations
Start of display items

State transition

FUNC+PROG key
Program setting status
ENTER key
(4)
DISP key
1st setting
registered
status
, key
(5)
, key
Check status of
program or delete
CLEAr
8-2
Start programming by pressing the FUNC and PROG keys in the normal display
mode.
In the program setting state, PRG LED on the console lights and the decimal points in
the program number display and the segment number display lights. Note, however, that
the program setting state cannot be entered in the following cases.
• In the constant value control mode (and the constant value control data
to 1)
• When keylock is engaged (and variable parameters
In the following condition changes cannot be made in the program setting state.
• When a program is protected (and variable parameter
When programming is started, the number of the started program and its segment are
displayed.
The figure below shows the transition of states during programming.
The numbered items (1) to (19) are described on the following page.
(1)
(19)
DISP key
(2)
, key
ENTER key
FUNC+CLR key
(12)
ENTER key
(6)
FUNC+CLR key
(7)
FUNC+ENTER key
(Pattern item)
(8)
FUNC+CLR key
(Pattern item)
ENTER key
(9)
DISP key
Normal display mode
(3)
, key
FUNC+PROG key
(16)
Set point display status
(11)
DISP key
(12)
2nd setting
registered
status
, key
(10)
, key
ConSt
PA01
is set to 2 or 3)
PA02
is set to 1, 3 or 5)
DISP key
, key
(17)
, key
ENTER key
(18)
Program number or
segment number flashes
FUNC+ENTER
(13)
key ENTER key
(Pattern item)
DISP key
(15)
Check before inserting
or deleting segments
. flashes
InS
. flashes
dEL
, key
is set
(19)
(14)