Key Chord Functions - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 2. NAMES AND FUNCTIONS OF PARTS
Classification
Program setting Erases or resets a set value.
(When a set value flickers.)
Cancels change in set value.
(When a set value flickers.)
Inserts or delete a segment when a pattern SP setting is started.
Changes RAMP-X
pattern SP setting is completed.
Starts a program number change.
Ends program setting.
Starts program copy. (In basic display status)
Program copy
Changes program number at copy destination.
Executes the copy.
(When a set value flickers.)
Ends program copy.
Memory card Starts a data write operation to the memory card.
operation (In basic display status)
(available on the
Writes data to the memory card.
DCP551E*****
model only)
Starts a data read operation from the memory card.
(In basic display status)
Reads data from the memory card.
Changes selected memory card operation.
Enters memory card operation.
Interrupts memory card operation.
Returns a check status of the general reset. (In basic display status)
General reset
Executes a general reset.
Interrupts a general reset.

■ Key chord functions

PROG + RUN/HOLD : Reset key
PROG + DISP
FUNC + →
2-6
RAMP-T or RAMP-X
Press the RUN/HOLD key while holding down the PROG key in basic status display
to perform a RESET.
The READY mode is invoked when a reset is performed in the RUN, HOLD, FAST, END,
or READY FAST modes. This RESET operation does not work in the READY mode.
: Advance key
Press the DISP key while holding down the PROG key in the program run mode in
basic status display to perform an ADV (advance) operation. The next segment is dis-
played when this action is performed in the RUN, HOLD, FAST, END, or READY
FAST modes. This ADV operation does not work in the READY mode.
: Fast key
Press the → key while holding down the FUNC key in the program run mode in basic
status display to perform a FAST operation.
The system changes from the RUN or HOLD mode to the FAST mode. If the system is
in the READY mode, it goes to the READY FAST mode.
Function
RAMP-E when a
Key operation
FUNC + CLR
DISP
FUNC + ENTER
FUNC + PROG
DISP
+ PROG
ENTER
DISP
SAVE
LOAD
ENTER
DISP
FUNC + CLR + MESSAGE
ENTER
DISP