Setting Pv Start Items - Honeywell DCP551 Mark ΙΙ User Manual

Chapter 8. PROGRAM SETUP

Setting PV start items

Display
NOTE
8-16
(1) In the set value display state, move to the PV start item to be set for the segment on
the programming map.
(A PV start item is a program setting and is the same for each segment.)
(2) Press the ENTER key to make display panel 2 flash (registration of first setting).
(3) Use the ↑, ↓, ←, and → keys to make the first setting – setting the PV start value.
Setting range:0 to 3
0: no PV start
1: descending PV start
2: ascending PV start
3: bi-directional PV start
(4) Press the ENTER key to stop the flashing on display panel 2.
(Pressing the FUNC and CLR keys causes display panel 2 to return to unset state
0
" " and the flashing stops.)
Set PV start value
P V S T A R T
• A PV start item is a program setting and is the same for each segment.
C60
• When setup data is set to 1, a PV start item on the programming map is skipped
and not displayed.
A PV start item setting does not use subfunctions.
PROG SEG
Program
Segment
number
number
PROFILE
Pattern trend