Honeywell DCP551 Mark ΙΙ User Manual page 21

Display panel 1
Indicates PV and other data in basic display status.
Indicates item codes in parameter setting status.
Indicates set values and item codes in program setting status.
Display panel 2
Indicates SP, time, output and other data in basic display status.
Indicates set values in parameter setting status.
Indicates set values in program setting status.
Message display
Indicates output graph, deviation graph, running progress graph, event status, pro-
gram tag and other data in basic display status.
Displays reference messages in parameter setting status.
Displays tag settings and reference messages in program setting status.
Indicates selected operation and operation results during memory card operation.
Program number display
Indicates a selected program number in basic display status.
Indicates a set program number in program setting status.
Off during constant value control.
Indicates the alarm code "
Segment number display
Indicates a selected segment number in basic display status.
Indicates a set segment number in program setting status.
Off during constant value control.
Indicates an alarm code number when an alarm occurs in basic display status.
Mode display LED
RUN, HLD : Indicates the RUN, HOLD, FAST, END, and READY FAST modes
(see the table below).
Mode
READY
LED
RUN OFF
HLD OFF
: Lights in MANUAL mode. Off in AUTO mode.
MAN
PRG : Lights in program setting status, otherwise off.
AT : Flickers during auto tuning execution, otherwise off.
: Flickers when battery voltage is too low, otherwise off.
BAT
EG1, EG2 : Lights when an event number output set by
ON setting. Off when set to OFF.
Profile display
Indicates the rising, soaking, and falling trends of a program pattern.
Flickers during G.SOAK wait and lights continuously after power on.
Chapter 2. NAMES AND FUNCTIONS OF PARTS
AL
" when an alarm occurs in basic display status.
RUN HOLD
Lights OFF
OFF Lights
FAST END
READY FAST
Flicker OFF Lights
OFF Flickers Lights
PA41 PA42
or is set to
2-3