Loader Jack - Honeywell DCP551 Mark ΙΙ User Manual

: Event configuration setting key
FUNC + PARA
: Constant value control setting key
FUNC + PID
: Program setting (programming) key
FUNC + PROG
FUNC + CLR : Program delete key
FUNC + ENTER : Segment insert/remove/RAMP/selection key
↑ + PROG : Program copy key
FUNC + CLR + MESSAGE : General reset key

Loader jack

Press the PARA key while holding down the FUNC key in basic status display to
switch to the event configuration setting status.
Press the PID key while holding down the FUNC key in basic status display to switch
to the event configuration setting status.
Press the PROG key while holding down the FUNC key in the program run mode in
basic status display to go to the program setting (programming) status.
When the PROG key is pressed while holding down the FUNC key in the program
setting status, allows you to change the number of the program to be set.
Press the CLR key while holding down the FUNC key during registration in the pro-
gram setting status to delete a setting or return to a default value.
Press the ENTER key while holding down the FUNC key to go to the segment
insert/delete panel during SP and time setting in the program setting status.
Pressing the ENTER key while the FUNC key is held down during SP registration in
the program setting status allows you to switch between RAMP-X and RAMP-T as well
as RAMP-X and RAMP-E.
Press the PROG key while holding down the ↑ key in program run READY mode in
basic display status to go to the program copy panel.
Press the CLR and MESSAGE keys simultaneously while holding down the FUNC
key in the READY AUTO mode in the basic display status to go to the general reset
verification panel.
This jack allows the connection of a loader.
Do not insert plugs other than loader plugs.
The loader jack is not isolated from internal digital circuits.
When not in use, always replace the cap.
Chapter 2. NAMES AND FUNCTIONS OF PARTS
2-7