Selecting Programs - Honeywell DCP551 Mark ΙΙ User Manual

Selecting programs

Binary system
External switch number Weight
SW9
SW10
SW11
SW12
SW13
SW14
SW15
Number selection
• Programs can be selected using the external switches in the READY program run
mode.
• Programs are selected using the external switches and the BCD system or the binary
system, and are set in setup data
are used to set the one digit and the four switches SW13 to 16 are used to set the ten
digit. In the binary system, seven switches SW9 to 15 are used to set, and the switch
SW16 is not used. Settings made with these systems are shown in the tables below.
BCD system (the one digit)
External switch number Weight
SW9 1
SW10 2
SW11 4
SW12 8
Number selection
BCD system (the ten digit)
External switch number Weight
SW13 10
SW14 20
SW15 40
SW16 80
Number selection
1 OFF ON
OFF OFF
2
OFF OFF
4
8 OFF OFF
16
OFF OFF
32
OFF OFF
64
OFF OFF
0 1
C75
. In the BCD system, four switches SW9 to 12
Status
OFF ON OFF ON OFF ON OFF ON OFF ON
OFF OFF ON ON OFF OFF ON ON OFF OFF
OFF OFF OFF OFF ON ON ON ON OFF OFF
OFF OFF OFF OFF OFF OFF OFF OFF ON ON
0 1 2 3 4
Status
OFF ON OFF ON OFF ON OFF ON OFF ON
OFF OFF ON ON OFF OFF ON ON OFF OFF
OFF OFF OFF OFF ON ON ON ON OFF OFF
OFF OFF OFF OFF OFF OFF OFF OFF ON ON
0 10 20 30 40
Status
OFF ON OFF ON
ON ON OFF OFF
OFF OFF ON ON
OFF OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
OFF OFF OFF OFF
¥ ¥ ¥ 13
2 3 4 5
Chapter 6. OPERATION
5 6 7 8 9
50 60 70 80 90
ON OFF ON OFF ON
OFF ON ON OFF OFF
ON ON ON OFF OFF
ON ON ON OFF OFF
OFF OFF OFF ON ON
OFF OFF OFF OFF OFF
OFF OFF OFF OFF OFF
14 15 16 17
6-9