Honeywell DCP551 Mark ΙΙ User Manual page 131

C52
(SP output lower limit)
C53
(SP output upper limit)
These are scaling settings of SP output. The high and low values for the upper and lower
limits can be reversed.
C63
(time display)
0: remaining segment time
1: total operation time
• These are selections for display panel 2 in the normal display mode in the program
• In the READY mode a setting of 0 displays the set time values for the selected seg-
• In the RUN, HOLD, FAST and END modes a setting of 0 displays the remaining
• In the READY mode a setting of 1 displays the time as "
• In the RUN, HOLD, FAST and END modes a setting of 1 means that the time is dis-
• In FAST mode a setting of 0 or 1 displays the time according to FAST X.
C66
(SP limit lower limit)
C67
(SP limit upper limit)
• These settings operate as limiters when SP is set or changed in the program setting
• In the program run mode these settings operate as limiters when SP and SP bias (vari-
• These settings operate as limiters when SP is set or changed in constant value control
• In the constant value control mode these settings operate as limiters when SP and SP
run mode.
ments.
time in rounded hours.
For example, when the time unit hours/min is selected a remaining time of 1 hour 30
minutes and 59 seconds is displayed as "
played in rounded hours after a change from the READY mode to the RUN mode. In
G.SOAK wait, repeat, cycle and pattern link, time is displayed as integrated values.
When the time unit is hours/min or min/sec, the display returns to "
499.59
" ". When the time unit is 0.1 sec, the display returns to "
2999.9
" ".
When the time unit is hour/min, a total operating time of 501 hours 30 minutes and 59
1.30
seconds is displayed as "
pattern items.
able parameter) set in a program are added to produce the resulting SP.
data settings.
bias (variable parameter) set in constant value control data settings are added to pro-
duce the resulting SP.
Chapter 7. PARAMETER SETUP
1.30
".
".
0.00
".
0.00
" after
0.0
" after
7-29