Concluding Steps - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

System board and components
Figure 295: Connecting cables to the system board (C)
Ê If applicable, run the front LAN cable through the cable clamp as shown.

14.6.4 Concluding steps

Ê Reconnect all remaining cables to the system board. For a complete cabling
overview, please refer to section
Ê Reinstall all remaining system board components as shown in the related
sections:
– Heat sinks: refer to section
– Memory modules: refer to section
page 249
I
Install all memory modules into their original slots.
– Expansion cards: refer to section
page 249
I
Install all expansion cards into their original slots.
– UFM (if applicable): refer to section
– TPM (if applicable): refer to section
386
"Cabling plans" on page
"Installing processor heat sinks" on page 268
Upgrade and Maintenance Manual
"Installing a memory module" on
"Installing a memory module" on
"Installing the UFM" on page 353
"Installing the TPM" on page 361
405.
TX150 S8 / TX200 S7