Removing A 2.5-Inch Hdd / Ssd Module - Fujitsu PRIMERGY TX150 S8 Upgrade And Maintenance Manual

Hard disk drives / solid state drives
For further information, please refer to the "ServerView Suite RAID
Management" user guide.
"Removing accessible drive and HDD bay covers" on page 60
Ê
7.2.4.2

Removing a 2.5-inch HDD / SSD module

Figure 70: Removing a 2.5-inch HDD / SSD module
Ê Pinch the green locking clips and fully open the locking lever (see figure 68).
Ê Wait about 30 seconds to allow the hard disk drive to spin down.
I
This is not necessary when removing a solid state drive.
Ê Pull the HDD / SSD module completely out of its bay.
146 Upgrade and Maintenance Manual
TX150 S8 / TX200 S7