7.14 Transferring Setting Data
7.14.1 Uploading Setting Data from Positioning Unit
Read the parameters and positioning data of the positioning unit.
1. Make the connection between a PC and PLC, and configure the settings. Then, select [File]
[Upload from Unit] in the menu bar, or click the [Upload from Unit] icon in the toolbar.
2. Execute reading the unit.
Note:
The process of reading may take for a few minutes. Click [Cancel] to stop the read.
3. When the read completes successfully, a message asking if the data comment will be held is
indicated.
- Click [Yes] to leave all the comments set in the data.
- Click [No] to clear all the comments.
Note:
To execute the upload, previously determine the target positioning unit by the communication settings
and selecting the slot number.
The data comments are not stored in the positioning unit. They are managed in the setting files of the PC.
7-27