Parameter Setting Area - Panasonic FP2-PP2T Technical Manual

17.6.2 Parameter Setting Area

Positioning parameters of each axis
Data in the following foramts are stored from the starting address of positioning parameters of each axis.
Offset
Name
address
000H Unit setting
001H -
002H
Pulse number
per rotation
003H
004H
Movement
amount per
rotation
005H
006H -
Descriptions
Sets the unit system of movement amounts of the positioning control for each axis.
The same unit system should be set for all interpolation axes.
-
Sets the pulse number per rotation. It is necessary for the conversion of the pulse
number in the settings of mm, inch and degree.
Sets the movement amount per rotation. It is necessary for the conversion of the
pulse number in the settings of mm, inch and degree.
-
Default Setting
Unit
value range
17-29