Panasonic FP2-PP2T Technical Manual page 78

Parameter name
Software limit (Positioning control)
Software limit (Home return)
Software limit (JOG operation)
Upper limit of software limit
Lower limit of software limit
Auxiliary output mode
Auxiliary output ON time (ms)
Moving amount check
Moving amount check value (Pulse)
Moving amount check correction
numerator
Moving amount check correction
denominator
Moving amount check time (ms)
Startup speed
Home return – Setting code
Home return – Direction
Home return – Acceleration time
Home return – Deceleration time
Home return – Target speed
Home return – Creep speed
Home return – Coordinate origin
JOG operation – Acceleration/
Deceleration pattern settings
JOG operation – Acceleration time
JOG operation – Deceleration time
JOG operation – JOG target rate
Emergency stop deceleration time
(ms)
Limit stop deceleration time (ms)
Error stop deceleration time (ms)
J point control – Accel./Decel.
Pattern
J point control – Acceleration time
(ms)
J point control – Deceleration time
(ms)
J point control – Target speed
Pulser operation setting code
Pulse input method
Pulser operation ratio numerator
Pulser operation ratio denominator
Pulse operation maximum speed
7-16
Description
Enable/disable the software limit in the positioning control.
Enable/disable the software limit in the home return.
Enable/disable the software limit in the JOG operation.
The upper limit value of the software limit.
The lower limit value of the software limit.
Enable/disable the auxiliary output contact and auxiliary output
code.
The time that the auxiliary output contact is ON.
The operation after checking the moving amount when using
the moving amount check function.
The checking threshold for the moving amount check function.
Execute the moving amount check function by multiplying the
pulse input value by the following ratio.
(Moving amount check correction numerator) / (Moving amount
check correction denominator)
The time interval for executing the moving amount check
function.
The startup speed for all operations (Initial speed)
The pattern of the home return.
The operating direction of the home return.
The acceleration time in the home return.
The deceleration time in the home return.
The target speed in the home return.
The speed to search the home position after the proximity
input.
The current value after the completion of the home return.
The acceleration/deceleration pattern mode in the JOG
operation.
The acceleration time in the JOG operation.
The deceleration time in the JOG operation.
The target rate in the JOG operation.
The deceleration time when the emergency stop is requested
by the input contact.
The deceleration time for the deceleration operation when the
limit is input.
The deceleration time for the deceleration operation when an
error occurs
The acceleration/deceleration pattern mode when performing
the J point control (speed point)
The acceleration time when performing the J pont control
(speed point)
The deceleration tiem when performing the J point control
(speed pont)
The target speed when performing the J point contro. (speed
point)
The pulser input (1 to 3) in the pulser operation.
The input method in the pulser operation
No. of movement pulse is calculated by multiplying the No. of
input pulse from the pulser by the ratio below.
(Numerator of ratio of pulser operation)/(Denominator of ratio of
pulser operation)
The maximum operation speed in the pulser operation