Panasonic FP2-PP2T Technical Manual page 153

Setting
The parameters necessary for the setting of the pulser operation are specified by the Configurator PM.
The unit is set to pulse.
Item
Operation setting code
Pulser operation ratio numerator
Pulser operation ratio denominator
Pulser operation method
Pulser operation max. speed
Operation diagram
Operations of each contact
The BUSY flag (X18) indicating the state that a motor is running turns on when a pulser operation
-
enabled contact turned on, and it turns off when the pulser operation enabled contact turned off.
The operation done flag (X20) indicating the state that an operation completed turns on when an pulser
-
operation enabled contact turned off, and it will be held until any operation among the position control,
JOG operation, Home return and pulser operation starts.
Sample program
Setting example
0: Pulser 1 0: Pulser 1, 1: Pulser 2, 2: Pulser 3
2 1 to 32,767
1 1 to 32,767
2: Speed limit 0: Standard 1: Speed limit (keep pulse)
(cutoff) 2: Speed limit (cutoff)
500 Pulse: 1 to 32,767,000 kpps
Allowable range
11-3